HP New 2024 HPE6-A72 Test Tutorial (Updated 107 Questions)
HPE6-A72 Exam Questions Dumps, Selling HP Products
The ACSA certification is an excellent way for IT professionals to demonstrate their expertise in Aruba switching technology. It is a valuable credential for professionals who work in networking, wireless, and security roles. The ACSA certification is also a prerequisite for advanced Aruba certifications, such as the Aruba Certified Switching Professional (ACSP) and the Aruba Certified Design Expert (ACDX). By earning the ACSA certification, IT professionals can differentiate themselves from their peers and enhance their career prospects.
NEW QUESTION # 23
Refer to the exhibit.
What commands will successfully enable the SVI for vlan 100 on interface 1/1/1 to produce the results displayed in the commandshow ip interface briefin the exhibit below?
- A. Access-1(config-if)# vlan 100
Access-1(config-vlan)# ip address 10.1.1.1/24 - B. Access-1(config)# interface 1/1/1
Access-1(config-if)# vlan trunk permit vlan 100
Access-1(config-if)# interface vlan 100
Access-1(config-if-vlan)# ip address static 10.1.1.1/24 - C. Access-1(config)# interface 1/1/1
Access-1(config-if)# routing
Access-1(config-if)# interface vlan 100
Access-1(config-if-vlan)# ip address 10.1.1.1/24 - D. Access-1(config)# interface vlan 100
Access-1(config-if-vlan)# ip address 10.1.1.1/24
Answer: D
NEW QUESTION # 24
Which two options are the Layer 3 Routing protocols? (Choose two.)
- A. MPLS
- B. 802.3ad
- C. LLDP
- D. BGP
- E. OSPF
Answer: D,E
NEW QUESTION # 25
What is the correct description of a Multi-Layer Switch?
- A. a switch with Layer 3 routing capabilities but lacks any Layer 1 features as a consequence
- B. any switch that supports PoE, LLDP-MED and Flow Control
- C. multi-Layer refers specifically to using chassis switches with several line cards over stack port switches
- D. has all the functionality of a Layer 2 switch and most of the functionality of a Layer 3 router
Answer: D
NEW QUESTION # 26
Which two port characteristics must match between LAG interfaces? (Choose two.)
- A. Duplex
- B. Port number
- C. Chassis number
- D. Member ID
- E. Media type
Answer: A,E
NEW QUESTION # 27
What is the login and password combination is used when first configuring an Aruba OS-CX switch from factory defaults?
- A. Login admin and password field empty.
- B. Login admin and password admin.
- C. Login admin and password forgetme!
- D. Login admin and password password.
Answer: A
NEW QUESTION # 28
Review the exhibit.
As the frame traverses from **PC-1** to **Server-1**, the VLAN tag will be removed.
Click on the interface (circled in green) where the VLAN tag will be removed.
Answer:
Explanation:
NEW QUESTION # 29
Refer to the exhibit.
You are in the process of configuring VSF between Access-1 and Access-2. Access-1 has been configured as the VSF Master.
What is a valid configuration for Access-2 to join the VSF stack?
- A. Access-2# configure
Access-2(config)# vsf member 2 Access-2(vsf-member-1)# link 2 1/1/28 Access-2(vsf-member-1)# exit This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y - B. Access-2# configure
Access-2(config)# vsf member 2 Access-2(vsf-member-1)# link 1 1/1/28 Access-2(vsf-member-1)# exit This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y - C. Access-2# configure
Access-2(config)# vsf member 1 Access-2(config)# vsf renumber-to 2 Access-2(vsf-member-1)# link 2
2/1/28 Access-2(vsf-member-1)# exit
This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y - D. Access-2# configure
Access-2(config)# vsf member 1 Access-2(vsf-member-1)# link 1 1/1/28 Access-2(vsf-member-1)# exit Access-2(config)# vsf renumber-to 2 This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y
Answer: B
NEW QUESTION # 30
Which command can be used to find the serial number of an Aruba OS-CX switch?
- A. The command show system
- B. The command show running-configuration
- C. The command inventory
- D. The command version
Answer: A
Explanation:
Explanation/Reference:
NEW QUESTION # 31
Refer to the exhibit
What is true regarding VLAN 50 according to the diagram above?
- A. VLAN 50 was never added to the vlan-database and therefore is in a down state.
- B. VLAN 50 is assigned only to Trunk ports which is why no ports are listed under interfaces.
- C. Since VLAN 50 has not been assigned to any enabled physical port, the status is down.
- D. VLAN 50 is part of a switched virtual interface (SVI) that was never routed causing it to be down.
Answer: C
NEW QUESTION # 32
What are two available options as part of a DHCP offer message? (Choose two.)
- A. Subnet Mask
- B. SSID
- C. LLDP-MED
- D. VLANID
- E. DNS server IP
Answer: A,E
NEW QUESTION # 33
What is true about VSX? (Choose two.)
- A. VSX is available on all Aruba OS-CX switches except the 6300F model.
- B. VSX allows upgrading members with near zero downtime or loss of packets.
- C. VSX run separate control planes to reduce latency and improve performance.
- D. VSX is ideal for Campus access layer deployments where ease of deployment is needed.
- E. VSX is implemented on static port switches. VSX-plus needed to stack chassis together.
Answer: B,C
NEW QUESTION # 34
Refer to the exhibit
What is true regarding VLAN 50 according to the diagram above?
- A. VLAN 50 was never added to the vlan-database and therefore is in a down state.
- B. VLAN 50 is assigned only to Trunk ports which is why no ports are listed under interfaces.
- C. Since VLAN 50 has not been assigned to any enabled physical port, the status is down.
- D. VLAN 50 is part of a switched virtual interface (SVI) that was never routed causing it to be down.
Answer: C
NEW QUESTION # 35
Aruba Access Points tunnel traffic in a campus to the Mobility Controller using which protocol?
- A. Process Application Programming Interface (PAPI)
- B. Lightweight Access Point Protocol (LWAPP)
- C. Control and Provisioning of Wireless Access Points (CAPWAP)
- D. Generic Routing Encapsulation (GRE)
Answer: D
NEW QUESTION # 36
What are two key features unique to AOS-CX that support root cause analytics and recovery in a wired network? (Select two.)
- A. Checkpoints
- B. Multi-Protocol Border Gateway Protocol (MP-BGP)
- C. Network Analytics Engine
- D. Redundant management modules
- E. REST APIs
Answer: A,C
NEW QUESTION # 37
Refer to the exhibit.
The above output is the result of issuing the command show system resource-utilization.
What command should be used to enable terminal output line by line or page by page?
- A. The command less
- B. The command terminal length 30
- C. The command more
- D. The command page
Answer: D
NEW QUESTION # 38
Place the OSI Layers in the correct order. Arrange them from least to greatest, starting with Layer 1 on the top, and progressing to Layer 7 on the bottom.
Answer:
Explanation:
1 - physical Layer
2 - Data Link Layer
3 - Network Layer
4 - Transport Layer
5 - Session Layer
6 - Presentation Layer
7 - Application Layer
NEW QUESTION # 39
Match each description to the correct term.
Answer:
Explanation:
NEW QUESTION # 40
What is the process where a compute device converts logical data bits into the correct physical representation depending on the media?
- A. Propagation
- B. Encapsulation
- C. Demodulation
- D. Modulation
Answer: B
NEW QUESTION # 41
Click on the colored box that corresponds with the line that best represents Unicast traffic flow.
Answer:
Explanation:
NEW QUESTION # 42
What are the commands to disable SSH and HTTPS services from the default VRF?
- A. Core-1(config)# no ssh server enable
Core-1(config)# no https-server enable - B. Core-1(config)# no ssh server
Core-1(config)# no https-server - C. Core-1# no ssh server vrf default
Core-1# no https-server vrf default - D. Core-1(config)# no ssh server vrf default
Core-1(config)# no https-server vrf default
Answer: D
NEW QUESTION # 43
What is a benefit of choosing a 3-Tier design with routing at the Aggregation layer?
- A. Connecting WAN/MPLS and Data center access to the Aggregation layer
- B. Better Core router performance by offloading processing
- C. Using access control lists (ACLs) at the Core to improve performance
- D. Shifting endpoint access to the Aggregation layer from the Access layer
Answer: B
NEW QUESTION # 44
Refer to the exhibit.
What commands will successfully enable the SVI for vlan 100 on interface 1/1/1 to produce the results displayed in the command show ip interface brief in the exhibit below?
- A. Access-1(config-if)# vlan 100
Access-1(config-vlan)# ip address 10.1.1.1/24 - B. Access-1(config)# interface 1/1/1
Access-1(config-if)# vlan trunk permit vlan 100
Access-1(config-if)# interface vlan 100
Access-1(config-if-vlan)# ip address static 10.1.1.1/24 - C. Access-1(config)# interface 1/1/1
Access-1(config-if)# routing
Access-1(config-if)# interface vlan 100
Access-1(config-if-vlan)# ip address 10.1.1.1/24 - D. Access-1(config)# interface vlan 100
Access-1(config-if-vlan)# ip address 10.1.1.1/24
Answer: D
NEW QUESTION # 45
Which two statements are true about the state of a new HPE Aruba Networking CX 6300 Series switch on factory defaults? (Select two.)
- A. For the CX 6300M switch, all up-link ports and switchports are configured as access mode.
- B. LLDP is enabled on up-link ports and switchports for the CX 6300M.
- C. The CX 6300M up-link ports only support routed mode. All other ports only support access mode.
- D. The CX 6300M has support for IP addressing applied to switched virtual interfaces (SVIs) but not on routed ports.
- E. LLDP is not enabled but is supported on all AOS-CX switches.
Answer: A,B
NEW QUESTION # 46
Refer to the exhibit.
Which command produces the above output?
- A. show vlan port 1/1/10
- B. show trunk port 1/1/10 extended
- C. show interface port 1/1/10 switchport
- D. show interface port 1/1/10 trunk
Answer: B
NEW QUESTION # 47
......
HP HPE6-A72 exam consists of 60 multiple-choice questions that must be completed within 90 minutes. HPE6-A72 exam is administered by Pearson VUE and is available in multiple languages. Candidates who pass the exam will demonstrate that they have the knowledge and skills necessary to configure and manage Aruba switches, troubleshoot common network issues, and implement advanced switching technologies. The ACSA certification is a valuable credential that can help IT professionals advance their careers and increase their earning potential.
HPE6-A72 Cert Guide PDF 100% Cover Real Exam Questions: https://www.dumps4pdf.com/HPE6-A72-valid-braindumps.html
Pass HPE6-A72 Review Guide, Reliable HPE6-A72 Test Engine: https://drive.google.com/open?id=1XeXIQRSxZg1XKRPsQgx2jbp5B_CixvMm