[Dec-2023] HP HPE6-A72 Dumps - Secret To Pass in First Attempt
HP HPE6-A72 Exam Dumps [2023] Practice Valid Exam Dumps Question
NEW QUESTION # 38
Review the exhibit.
As the frame traverses from **PC-1** to **Server-1**, the VLAN tag will be removed.
Click on the interface (circled in green) where the VLAN tag will be removed.
Answer:
Explanation:
NEW QUESTION # 39
What command displays information regarding the secondary image installed on an AOS-CX switch?
- A. show version
- B. show secondary
- C. show version detail
- D. show images
Answer: D
NEW QUESTION # 40
Which statement is true regarding modern switching requirements?
- A. Most older legacy switches had high port bandwidth utilization and were future proof designed to meet today's power-over-Ethernet needs.
- B. Clients tend to prefer wireless connections, raising the need for PoE port access. There is also a growing amount of IoT devices that require security and port authentication options.
- C. Requirements for PoE are normally addressed using AC to DC power adapters. Concerns for port security for IoT devices are usually addressed using default wired encryption that all 802.3 Ethernet switches provide.
- D. While APs are common, most clients are still docked and only require traditional wired connections with only the occasional dedicated PoE switch to provide power for the low number of devices needed.
Answer: B
NEW QUESTION # 41
Which statement is correct regarding powering an Aruba Access Point?
- A. PoE or PoE+ is only used with Ethernet that is carried over multi-mode fiber cabling.
- B. Most administrators use PoE or PoE+ enabled switchports to provide both Ethernet connectivity and power to the AP.
- C. Using switchports for this reason is unnecessary, because Aruba Access Points typically use an AC to DC power adapter to draw power.
- D. PoE or PoE+ enabled switchports are rarely used given concerns about causing electrical interference, with the data also carried over Ethernet cabling.
Answer: B
NEW QUESTION # 42
What is the Link Layer Discovery Protocol?
- A. a standardized protocol for communicating directly-connected device information and capabilities.
- B. an Aruba proprietary discovery protocol supported in all Aruba switches along with Cisco Discovery Protocol or CDP
- C. a discovery protocol used between Layer 3 devices to determine routes within a single autonomous system
- D. a standardized IPv6 neighbor discovery protocol used to replace the ARP and broadcast mechanism used in IPv4
Answer: A
NEW QUESTION # 43
Refer to the exhibit.
All switches are running Aruba OS-CX. While working in the terminal of Access-2, you are unable to reach Server-1 using SSH.
What is the correct command to ping Server-1 from Access-2 to test reachability?
- A. Access-2# ping 172.16.1.97
- B. Access-2# ping6 172.16.1.97 vrf mgmt.
- C. Access-2# ping 172.16.1.97 vrf default
- D. Access-2# ping 172.16.1.97 vrf mgmt
Answer: D
NEW QUESTION # 44
Which field in the IPv4 header indicates whether the IP packet carries TCP or UDP traffic?
- A. IHL
- B. TTL
- C. Identification
- D. Protocol
Answer: D
NEW QUESTION # 45
Which two options are correct regarding the IEEE 802.11ax standard? (Choose two.)
- A. operates in both the 2.4GHz and 5GHz radios bands
- B. is the first WLAN standard to no longer use electromagnetic signals to transmit data
- C. operates only in the 5GHz similar to 802.11ac
- D. allows transmissions of up to 4.8Gbps
- E. is an emerging satellite connection standard to allow wireless access anywhere in the world
Answer: A,D
Explanation:
Explanation/Reference:
NEW QUESTION # 46
Match the terms to the correct layer of the OSI model.
Answer:
Explanation:
NEW QUESTION # 47
Which option correctly describes a WAN network?
- A. compute resources that are networked locally over wireless
- B. a network of devices over long distances but limited to within a single ISP
- C. the connection between two separate buildings in the same campus
- D. a group of computer resources that communicates between geographically separate location
Answer: D
NEW QUESTION # 48
What is true about VSX? (Choose two.)
- A. VSX run separate control planes to reduce latency and improve performance.
- B. VSX is ideal for Campus access layer deployments where ease of deployment is needed.
- C. VSX allows upgrading members with near zero downtime or loss of packets.
- D. VSX is implemented on static port switches. VSX-plus needed to stack chassis together.
- E. VSX is available on all Aruba OS-CX switches except the 6300F model.
Answer: A,C
NEW QUESTION # 49
Match the term to the correct description.
Answer:
Explanation:
NEW QUESTION # 50
Which two statements accurately describe stacking with Aruba switches? (Choose two.)
- A. A VSF stack is allowed between an AOS 5400R and an AOS-CX 6400.
- B. The VSF feature is not compatible between AOS-CX and AOS platforms.
- C. A VSF stack is allowed between an AOS-CX 6300M and 6300F switches.
- D. VSF is a core or aggregation layer stacking technology due to the high resiliency of sharing a single control plane.
- E. VSF and VSX are stacking option with the AOS-CX 8320. 8325. 8400. and 6400 models.
Answer: D,E
NEW QUESTION # 51
Click on the colored box that corresponds with the line that best represents Broadcast traffic flow.
Answer:
Explanation:
NEW QUESTION # 52
Refer to the exhibit.
You are in the process of configuring VSF between Access-1 and Access-2. Access-1 has been configured as the VSF Master.
What is a valid configuration for Access-2 to join the VSF stack?
- A. Access-2# configure
Access-2(config)# vsf member 1 Access-2(config)# vsf renumber-to 2 Access-2(vsf-member-1)# link 2 2/1/28 Access-2(vsf-member-1)# exit This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y - B. Access-2# configure
Access-2(config)# vsf member 2 Access-2(vsf-member-1)# link 2 1/1/28 Access-2(vsf-member-1)# exit This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y - C. Access-2# configure
Access-2(config)# vsf member 2 Access-2(vsf-member-1)# link 1 1/1/28 Access-2(vsf-member-1)# exit This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y - D. Access-2# configure
Access-2(config)# vsf member 1 Access-2(vsf-member-1)# link 1 1/1/28 Access-2(vsf-member-1)# exit Access-2(config)# vsf renumber-to 2 This will save the VSF configuration and reboot the switch. Do you want to continue (y/n)? y
Answer: C
NEW QUESTION # 53
What is the correct description of a Multi-Layer Switch?
- A. has all the functionality of a Layer 2 switch and most of the functionality of a Layer 3 router
- B. multi-Layer refers specifically to using chassis switches with several line cards over stack port switches
- C. a switch with Layer 3 routing capabilities but lacks any Layer 1 features as a consequence
- D. any switch that supports PoE, LLDP-MED and Flow Control
Answer: A
NEW QUESTION # 54
Click on the colored box that corresponds with the line that best represents Unicast traffic flow.
Answer:
Explanation:
NEW QUESTION # 55
What is an available command on an Aruba AOS-CX switch that would back up the secondary image to a secure remote repository?
- A. copy sftp://[email protected]/GL.10.04.0003.swi secondary
- B. copy secondary tftp://[email protected]/GL.10.04.0003.swi
- C. copy secondary sftp://[email protected]/GL.10.04.0003.swi
- D. backup secondary sftp://[email protected]/GL.10.04.0003.swi
Answer: C
NEW QUESTION # 56
Refer to the exhibit
Which command on Access-2 port 1/1/4 will enable connectivity between PC-1 and Server-1 without any routing enabled in the network?
- A. Access-2 (config-if-1/1/4)# vlan trunk allow 1, 10, 255
- B. Access-2 (config-if-1/1/4)# vlan access 1, 10, 20, 255
- C. Access-2 (config-if-1/1/4)# vlan access 20
- D. Access-2 (config-if-1/1/4)# vlan 20 untag 1/1/4
Answer: C
NEW QUESTION # 57
The section in blue can be ignored.
SW1(config)# interface 1/1/1-1/1/2
SW1(config-if-<1/1/1-1/1/2)# vlan access 2
SW1(config-if-<1/1/1-1/1/2)# exit
SW1(config)# interface 1/1/11-1/1/17
SW1(config-if-<1/1/11-1/1/17)# vlan access 17
SW1(config-if-<1/1/11-1/1/17)# exit
After completing the above commands, what is the expected output of show vlan with no other vlan commanded having been added?
- A. Option C
- B. Option B
- C. Option D
- D. Option A
Answer: C
NEW QUESTION # 58
Which two commands will save the running-config so that changes will be loaded automatically on the next reboot? (Choose two.)
- A. write memory
- B. copy running-config checkpoint boot-config
- C. save
- D. copy config config1 config startup-config
- E. copy running-config startup-config
Answer: A,E
NEW QUESTION # 59
Which command can be used to find the serial number of an Aruba OS-CX switch?
- A. The command show system
- B. The command show running-configuration
- C. The command inventory
- D. The command version
Answer: A
NEW QUESTION # 60
What are two OSPF attributes within the hello messages that must match to successfully establish neighbor relationships? (Choose two.)
- A. Process ID
- B. Priority
- C. Hello and Dead intervals
- D. Router ID
- E. Area ID
Answer: C,E
NEW QUESTION # 61
......
HPE6-A72 Exam Dumps PDF Guaranteed Success with Accurate & Updated Questions: https://www.dumps4pdf.com/HPE6-A72-valid-braindumps.html
HPE6-A72 Dumps - Grab Out For [NEW-2023] HP Exam: https://drive.google.com/open?id=1nQ-UsqZ7xG0WZBIDQLj000Vcn2DdANNz