[2022] Use Valid New 300-615 Test Notes & 300-615 Valid Exam Guide [Q40-Q59]

Share

[2022] Use Valid New 300-615 Test Notes & 300-615 Valid Exam Guide

300-615 Actual Questions Answers PDF 100% Cover Real Exam Questions

NEW QUESTION 40
Refer to the exhibit.

During implementation of a Cisco UCS C-Series Server, an engineer receives the status that is shown in the exhibit. Which action resolves the issue.

  • A. Reconfigure the Drive Type from "Removable" to "Non-Removable"
  • B. Configure the RAID that is associated with the card.
  • C. Insert an SD card into SLOT-2
  • D. Set SLOT-1 Sync Mode to "Auto"

Answer: A

 

NEW QUESTION 41
Refer to the exhibit.

A network engineer traces the packet flow from the Veth991 of a blade server toward the core switch. The switch reports performance issues What is the role of the interface Eth1/7?

  • A. fabric interconnect uplink interface
  • B. IOM network interface
  • C. server interface
  • D. IOM host interface

Answer: A

Explanation:
E1/7 is border interface, which is used as uplink. All other veth interfaces are SIF, which stands for Server Interface.

 

NEW QUESTION 42

Refer to the exhibit. The vPC between switch1 and switch2 does not work. Which two actions resolve the problem? (Choose two.)

  • A. Match the vPC domain ID between the two devices.
  • B. Configure the IP address on the interface.
  • C. Activate VLANs on the vPC.
  • D. Configure one of the switches as primary for the vPC.
  • E. Correct the configuration of the vPC peer link and the vPC peer keepalive.

Answer: A,C

Explanation:
Section: Network

 

NEW QUESTION 43
Refer to the exhibit.

When an engineer inserts 8-Gb FC SFP port 15 on a Cisco UCS Fabric Interconnect, the port fails. What is a possible cause of the issue?

  • A. Port 15 is configured as an Ethernet port.
  • B. Port 15 is configured for 4-Gb FC.
  • C. Port 15 is missing a license.
  • D. The polarity of the fiber cable is reversed.

Answer: B

 

NEW QUESTION 44
A customer configures HSRP between two data centers that are interconnected with OTV. The configuration succeeds, but traffic between two ESXi virtual hosts on the same site is routed suboptimally through the OTV overlay. Which two actions optimize the traffic? (Choose two.)

  • A. Filter HSRP traffic by using a Layer 3 VACL on the OTV edge devices.
  • B. Filter HSRP by using a Layer 2 MAC-list on the OTV edge devices.
  • C. Filter HSRP traffic by using a Layer 3 VACL on the ESXi vSwitch.
  • D. Disable first-hop redundancy.
  • E. Filter HSRP by using a Layer 2 MAC-list on the ESXi vSwitch.

Answer: A,D

Explanation:
Section: Network

 

NEW QUESTION 45
You have an ACI environment with three APICs, two spine switches, and four-leaf switches. You wipe and reboot all APICs first then leaf and spine switches one-by-one and successfully go through the Initial Setuo dialogue on the APIC 1 CIMC KVM console. When you log in to the APIC1 WebGUI, you notice that you do not see any directly connected leaf switches being discovered under Fabric > Inventory > Fabric Membership. What is the cause of the issue?

  • A. The leaf nodes were not erased properly, which caused a fabric parameters mismatch with the APIC1.
  • B. You forgot to enter the TEP Pool value during the Initial Setup dialogue on APIC1.
  • C. Rebooting the APICs and the leaf and spine switches after wiping them is not required.
  • D. The same Fabric Name value should be used before after wiping all devices.

Answer: B

Explanation:
Section: Compute Platforms

 

NEW QUESTION 46
Refer to the exhibit.

A network engineer is implementing a Cisco UCS environment. The environment consists of eight servers configured with the same service profile template and Windows 2012 installed. The VFC interfaces of five of these servers are showing the error shown in the exhibit. Which action resolves the issue?

  • A. Modify the vHBAs name in the storage connectivity policy
  • B. Modify the boot order in the boot policy
  • C. Decommission and recommission the servers
  • D. Configure upstream zoning

Answer: C

 

NEW QUESTION 47
Refer to the exhibit.

A network engineer has connected the Nexus switch management port to the Internet using DHCP to allow the Guest shell running on the switch to download Python packages. The engineer can ping google.com successfully from the Nexus switch, but the Guest shell failed to download any Python packages. Which action resolves the problem?

  • A. Update the Python packages on the Cisco Nexus switch directly.
  • B. Manually configure NTP in the Guest shell.
  • C. Manually configure DNS in the Guest shell, even if it is claimed on the Cisco Nexus switch through DHCP.
  • D. Connect Guest shell to data plane interfaces to be able to connect to the networks outside the Cisco Nexus switch.

Answer: C

 

NEW QUESTION 48

Refer to the exhibit. A network engineer traces the packet flow from the Veth991 of a blade server toward the core switch. The switch reports performance issues. What is the role of the interface Eth1/7?

  • A. fabric interconnect uplink interface
  • B. IOM network interface
  • C. server interface
  • D. IOM host interface

Answer: A

Explanation:
Section: Compute Platforms

 

NEW QUESTION 49
Refer to the exhibit.

The cURL command fails to complete. Which action resolves the problem?

  • A. Add -H "X-Auth-Token" to the command.
  • B. Change ".json" to ".xml" at the end of the URL.
  • C. Remove ".json\" from the URL.
  • D. Include -p "password" in the command.

Answer: D

 

NEW QUESTION 50
Refer to the exhibit.

HSRP adjacency fails to form between Nexus7K-1 and Nexus7K-2. Which action should be taken to solve the problem?

  • A. Configure the same HSRP priority between the two switches.
  • B. Configure the correct subnet mask on Nexus7K-1.
  • C. Configure preempt on one of the switches in the HSRP group.
  • D. Configure HSRP version 2 on Nexus7K-2.

Answer: D

 

NEW QUESTION 51
Refer to the exhibit.

An engineer troubleshoots the HSRP configuration and notes that the remote end uses HSRP version 1. The engineer sets the local HSRP to version 1, but the problem continues. Which action resolves the issue?

  • A. Run version 1 and version 2 HSRP on VLAN300 in the local data center.
  • B. Set the local group number as 300 in the remote data center configuration
  • C. Change the local group number to 255 or less and request that the remote data center matches the group member in its configuration.
  • D. Reduce the priority of the local HSRP to below 100 to force the local HSRP to standby and then change the version to version 1.

Answer: C

Explanation:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipapp_fhrp/configuration/xe-16/fhp-xe-16-book/fhp-hsrp-v2.pdf

 

NEW QUESTION 52
"A network engineer troubleshoots an issue at a Cisco data center environment with these conditions:
* The data center has Cisco Nexus 9000 Series Switches running the vPC setup.
* The gateway of the servers is an HSRP IP address between the VLAN interfaces configured on both Cisco Nexus switches.
* Some of the client application servers are implementing fast-path forwarding for the return traffic.
* Those servers are sending the return traffic to the VLAN interface MAC address instead of the HSRP MAC address.
The network engineer discovers that some traffic is dropped because it passes the vPC peer link to be forwarded out the vPC interface. What must be configured on the vPC switches to resolve the issue?

  • A. spanning-tree
  • B. peer-switch
  • C. peer-gateway
  • D. arp synchronize

Answer: C

 

NEW QUESTION 53
Refer to the exhibit.

A certificate is implemented on the security configuration on the Cisco ACI controller. A customer receives a "Connection Not Secure" error in a browser every time the customer logs in to the Cisco APIC GUI. Which action resolves the issue?

  • A. Include a private key with the certificate.
  • B. Configure a corporate certificate authority for the certificate.
  • C. Use a browser that supports keys of 2048 bits.
  • D. Add a 1536-bit key to the APIC GUI.

Answer: C

 

NEW QUESTION 54
Refer to the exhibit.

The connection between a Cisco Nexus 5548UP switch and a Cisco MDS switch fails to initialize. What is the cause of the issue?

  • A. Trunk mode must be activated.
  • B. VSAN 1 is suspended.
  • C. The interface is in an incorrect mode.
  • D. The SFP is unsupported.

Answer: B

 

NEW QUESTION 55
An engineer must replace a failed memory on a Cisco UCS B-Series Blade Server. After the replacement was done, the server has a "resolve slot" warning. Which server maintenance action resolves the issue?

  • A. Perform diagnostic interrupt on the server.
  • B. Reset the server.
  • C. Decomission the server.
  • D. Re-acknowlegement the server.

Answer: D

Explanation:
Section: Compute Platforms

 

NEW QUESTION 56
Refer to the exhibit.

An engineer is experiencing a problem when running a Docker container inside the Cisco Nexus 9000 bash shell. Which action resolves the issue?

  • A. Connect to bash as a different user
  • B. Add a new nameserver
  • C. Change VRF to management
  • D. Configure the mgmt0 interface

Answer: A

 

NEW QUESTION 57
Refer to the exhibits.



An engineer troubleshoots switch N5K1, which fails to receive traffic from the file server Which set of actions resolves this problem?

  • A. Assign native VLAN 10 with vfc111 and allow VLAN 1101 in trunk configuration.
  • B. Bind native VLAN 10 with Ethemet10/1/1 and allow VLAN 10 in trunk configuration
  • C. Bind native VLAN 10 with Ethemet1/10 and allow VSAN 101 in trunk configuration.
  • D. Assign native VLAN 10 with fc2.'l - 2 and allow VLAN 10 in trunk configuration.

Answer: B

 

NEW QUESTION 58
The external routes fail to propagate to leaf switches in Cisco ACI fabric Which two actions resolve the issue?
(Choose two.)

  • A. Associate the correct contract to the L30ut.
  • B. Enable the VTEP pool in the fabric
  • C. Specify the spine nodes as route reflectors
  • D. Configure an MP-BGP area.
  • E. Assign an MP-BGP AS number to the fabric.

Answer: C,E

 

NEW QUESTION 59
......


Career Opportunities

Passing the Cisco 300-615 exam on the first try will help you get the specialist- and professional-level certificates as well as demonstrate to the current or future employer that you are a specialist in the data center solutions field and worthy of the desired position. Thus, the roles that you can choose from include a Data Center Engineering Telecom Manager, a Data Center Systems Administrator, an Infrastructure Manager, a Data Center Technician, and a Data Center VMware Engineer. If you are thinking about what income to expect, you can imagine a range of $39,000-145,000 per year, depending on your title.

 

300-615 Exam questions and answers: https://www.dumps4pdf.com/300-615-valid-braindumps.html

Pass 300-615 Exam Info and Free Practice Test: https://drive.google.com/open?id=1-1_MfMGvVRo3VdPaVeHGNkBRg40UsZ4m