[Q144-Q162] Real Exam Questions 350-501 Dumps Exam Questions in here [Aug-2021]

Real Exam Questions 350-501 Dumps Exam Questions in here [Aug-2021]

Get Latest Aug-2021 Conduct effective penetration tests using 350-501

NEW QUESTION 144
Refer to the exhibit:

An engineer is preparing to implement data plane security configuration.
Which statement about this configuration is true?

A. Router 1 is the trigger router in a RTBH implementation.
B. Router 2 must configure a route to null 0 for network 192 168.1 0/24 for the RTBH implementation to be complete.
C. Router 1 must be configured with uRPF for the RTBH implementation to be effective.
D. Router 2 is the router receiving the DDoS attack

Answer: B

NEW QUESTION 145
Refer to the exhibit:

A network engineer is implementing a BGP routing policy.
Which effect of this configuration is true?

A. All traffic is assigned a local-preference of 30O regardless of its destination
B. All traffic that matches acl10 is allowed without any change to its local-preference
C. All traffic that matches acl10 is dropped without any change to its local-preference
D. If traffic matches acl10, it is allowed and its local-preference is set to 300

Answer: B

NEW QUESTION 146
Refer to the exhibit:

Which effect of this configuration is true?

A. It enables MPLS on the interface
B. It enables tagging for VLAN 12 on the interface
C. It enables AToM on interface gigabitethemet1/0
D. it creates a pseudowire class named Cisco

Answer: C

NEW QUESTION 147
Drag and drop the technologies from the left onto the correct definitions on the right.

Answer:

Explanation:

NEW QUESTION 148

Refer to the exhibit. An engineer is implementing Auto-RP and reviewing the configuration of the PE-A. Which configuration permits Auto-RP messages to be forwarded over this interface?

A. PE-A(config-if)#no ip pim bsr-border
B. PE-A(config-if)#ip pim sparse-dense-mode
C. PE-A(config-if)#ip igmp version 3
D. PE-A(config-if)#ip pim sparse-mode

Answer: B

Explanation:
Section: Services

NEW QUESTION 149
Drag and drop the OSs from the left onto the correct descnpt.ons on the right.

Answer:

Explanation:

NEW QUESTION 150
A network team has failed to implement IS-IS multitopology. What is the reason for it?

A. The routing process did not support extended metrics.
B. The routing process supported Level 1 only.
C. The router did not support VRFs.
D. The router did not have Cl$co Discovery Protocol and Cisco Express Forwarding disabled.

Answer: A

NEW QUESTION 151
ASN 65001 is peering with ASN 65002 to exchange IPv6 BGP routes. All routes that originate in ASN 65001 have a standard community value of 65001:100, and ASN 65002 is allowed to advertise only 2001
:db8:aaaa::/48. An engineer needs to update the ASN 65001 route-filtering configuration to meet these conditions:
* Looped routes into ASN 65001 and routes that have traversed 10 or more ASNs must be denied.
* Routes accepted into ASN 65001 must be assigned a community value of 65001:200.
Which configuration must the engineer apply to the ASN 65001 border router?

A. Option A
B. Option D
C. Option B
D. Option C
E. Option E

Answer: B

NEW QUESTION 152
Refer to the exhibit.

Router 1 is missing the route for the router 2 loopback 0. What should the engineer change to fix the problem?

A. the hello timers on Router 1 and Router 2 to be different
B. the area numbers on Router 1 and Router 2 to be similar
C. the wildcard mask network statement in OSPF of Router 2
D. Router 1 to be an ABR

Answer: B

NEW QUESTION 153
Refer to the exhibit:

Based on the show/ command output, which result m true after BGP session is established?

A. The IOS XR router advertises and accepts all routes to and from eBGP neighbor 192.168.2.2
B. No routes are accepted from the neighbor 192.168.2.2, nor are any routes advertised to it
C. The IOS XR router does not advertise any routes to the neighbor 192.168.2.2,but it accepts all routes from 192.168.2.2.
D. The IOS XR router advertises all routes to the neighbor 192.168.2.2, but it does not accept any routes from 192.168.2.2

Answer: B

NEW QUESTION 154
Refer to the exhibit.
An engineer applied a gRPC dial-in configuration on customer's router to provide connection multiplexing and two-way streaming. What does this configuration accomplish in a gRPC?

A. It specifies the encapsulation that is used tor daily and dial-out.
B. It specifies the encapsulation pushed by the client.
C. It specifies the encapsulation pushed by the server.
D. It excludes the encapsulation types gpbcompact and gpbkv.

Answer: C

NEW QUESTION 155
Drag and drop the multicast concepts from the left onto the correct descriptions on the right.

Answer:

Explanation:

Explanation
1: PIM-DM 2:IGMP 3:PIM-SM 3:shared tree 4:source tree

NEW QUESTION 156
Refer to the exhibit:

When implementing an LDP protocol, an engineer experienced an issue between two directly connected routers and noticed that no LDP neighbor exists for 1.1.1.1.
Which factor should be the reason for this situation?

A. LDP needs to be enabled on the R2 loopback interface
B. LDP needs to be enabled on the R2 physical interface
C. R2 sees the wrong type of hellos from R1
D. R2 does not see any hellos from R1

Answer: B

NEW QUESTION 157

Refer to the exhibit. Which three outcomes occur if the prefix list is added to the neighbor? (Choose three.)

A. 192.168.0.0/17 is permitted
B. 192.168.0.0/16 is permitted.
C. 192.168.0.0/19 is denied.
D. 192.168.0.0/19 is permitted
E. 192.168.0.0/16 is denied.
F. 192.168.0.0/17 is denied.

Answer: D,E,F

Explanation:
Section: Architecture

NEW QUESTION 158
Refer to the exhibit:

This configuration is being applied on an IOS XR router.
Which statement about this configuration is true?

A. It is used to set up configuration to poll network data
B. It is used to enable gRPC
C. It is used to create a streaming subscription with a 600-second interval
D. It is used to create a streaming subscription with a 60-second interval

Answer: D

NEW QUESTION 159
What is the function of the FEC field within the OTN signal structure?

A. It allows the sending devices to apply QoS within the OTN forwarding structure.
B. It allows source nodes to discard payload errors before transmitting data on the network.
C. It allows deep inspection of data payload fields.
D. It allows receivers to correct errors upon data arrival.

Answer: D

NEW QUESTION 160
Refer to the exhibit:

When implementing an LDP protocol, an engineer experienced an issue between two directly connected routers and noticed that no LDP neighbor exists for 1.1.1.1.
Which factor should be the reason for this situation?