HP HPE7-A11 Value Pack (Frequently Bought Together)

What is the recommended bandwidth of a VSX Inter-Switch Link?

• A. It should be equal to the sum of the uplink ports' bandwidth.
• B. It should be equal or higher than the speed of the uplink.
• C. It should be equal to the sum of the downlink ports' bandwidth.
• D. It should be the same speed as the one used for VSX Keepalive speed bandwidth.

A large multinational financial institution has contracted you to design a new full-stack wired and wireless network for their new 6-story regional office building. The bottom two floors of this facility will be retail space for a large banking branch. The upper floors will be carpeted office space for corporate users, each floor being approximately 100,000 sq ft (9290 sq m). Data centers are all offsite and will be out of scope for this project. The customer is underserved by its existing L2- based network infrastructure and would like to take advantage of modem best practices in the new design. The network should be fully resilient and fault-tolerant, with dynamic segmentation at the edge.
The retail space will include public guest Wi-Fi access. Retail associates will have corporate tablets for customer service, and there will be a mix of wired and wireless devices throughout the retail floors. The corporate users will primarily use wireless for connectivity, but several wired clients, printers, and hard VoIP phones will be in use.
The customer is also planning on renovating the corporate office space in order to take advantage of 'smart office' technology. These improvements will drive blue-dot wayfinding, presence analytics, and other location-based services.
The client has decided that more critical switch stacks supporting Contact Center resources will need to support greater than 600W of CL4 PoE and have redundant power supplies. These stacks will have approximately six members.
What would be the most economical choice switch series to meet these requirements?

• A. CX 6300F
• B. CX 6400
• C. CX 6200M
• D. CX 6100

Refer to the exhibit. Your client is deploying an HPE Aruba Networking solution where AOS-10 APs are configured in bridged mode and directly connected to AOS-CX access switches within a campus environment.

One of the top security priorities is to block user traffic to any destination that falls under the BrightCloud Web Classification of "Bot Nets". You've been asked to review and confirm the correct technical steps that will enable accurate identification, classification, and blocking of such traffic through Central managed policies and AOS-CX integration.
To block user access to the specified web destination(s) in this deployment model, which actions should be taken?

• A. Add an (access rules) rule type "Blocked Page URL" and select "Bot Nets" collection action Deny to your AP's group.
• B. Add an (access rules) rule type "Access Control" Web Category and select "Bot Nets" action Deny to your APs group.
• C. Add an (access rules) rule type "Access Control" Application Category and select "Bot Nets" action Deny to your APs group.
• D. Configure the switch to enforce auth-node client mode on AP edge ports with an unlimited max client setting'.

Hotspot Question
Mark the layer where Dynamic Multicast Optimization should be activated.

Which is true when it comes to HPE Aruba Networking Central licensing for gateways?

• A. WLAN Gateway licenses allow normal SD-Branch features within a campus.
• B. SD-Branch Gateway licenses allow normal WLAN Gateway features within a campus..
• C. Gateway normal licensing is subdivided into three categories: Foundation, Advanced, and Foundation Base.
• D. SD-WAN Gateway functionality requires security licensing.